How to set the length of the pin numbers to be used
1. Enter programming mode by entering the 4 digit pin number
twice (default pin 1234).
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 9 key the orange LED will now
flash.
3. Press 04 a long bleep will be heard.
4. Enter the length of the pin number you require (2,3,4,5 or 6).
If the length is the same as already programmed you will get a
conformation bleep.
If you have changed the length you will get 7 bleeps to say it has now
been changed.
Note:- Any pin numbers programmed into the system will be deleted if the
pin length is change.
How to Enable the door Bell function
Note:- If two doors are being controlled the bell function can not be used.
1. Enter programming mode.
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 2 key the orange LED will start
to flash.
3. Press the 0 key followed by the 2 key.
The door bell function is now on.
Note:- The * key is now used to ring the doorbell
How to Disable the door Bell function
1. Enter programming mode.
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 2 key the orange LED will start
to flash.
3. Press the 0 key followed by the 1 key.
The door bell function is now off.
10
EZ-LOCK Manual_Layout 5 04/04/2013 14:53 Page 10
Summary of Contents for EZ-LOCK
Page 1: ...USER MANUAL...