4
What’s in the box
Please confirm that the following accessories are in the box
when you open it.
Power cord x 1
Remote control unit (RC-1156) x 1
Batteries (AA, R6, SUM-3) x 2
Felt sheet x 3
Owner’s manual x 1
Warranty card x 1
Read this before operation
<
Be careful to avoid injury when moving the unit, on account
of its weight. Get someone to help you if necessary.
<
To protect easily scratched furniture, you may stick the felt
supplied with the unit to the feet.
<
As the unit may become warm during operation, always leave
sufficient space around the unit for ventilation.
<
The voltage supplied to the unit should match the voltage as
printed on the rear panel. If you are in any doubt regarding
this matter, consult an electrician.
<
Choose the installation location of your unit carefully. Avoid
placing it in direct sunlight or close to a source of heat. Also
avoid locations subject to vibrations and excessive dust, heat,
cold or moisture.
<
Do not place the unit on the amplifier/receiver.
<
Do not open the cabinet as this might result in damage to the
circuitry or electrical shock. If a foreign object should get into
the unit, contact your dealer or service company.
<
When removing the power plug from the wall outlet, always
pull directly on the plug, never yank the cord.
<
To keep the laser pickup clean, do not touch it, and always
close the disc tray.
<
Do not attempt to clean the unit with chemical solvents as
this might damage the finish. Use a clean, dry cloth.
<
Keep this manual in a safe place for future reference.
Before Use
“Super Audio CD” is a registered trademark.
“DSD” is a registered trademark.
The i.LINK logo is a trademark of Sony Corporation, registered
in the U.S. and other countries.
DO NOT MOVE THE UNIT DURING PLAYBACK
During playback, the disc rotates at high speed. Do NOT lift or
move the unit during playback. Doing so may damage the
disc or the unit.
WHEN MOVING THIS UNIT
When changing places of installation or packing the unit for
moving, be sure to remove the disc and return the disc tray to
its closed position in the player. Then, press the power switch
to turn the power off, and disconnect the power cord.
Moving this unit with the disc loaded may result in damage to
this unit.
Restoring factory default settings
Memorized settings are stored even the power cord has been
disconnected.
If you have made a lot of changes to the setup process, and
want to restart from a known set of options, restore the unit to
the default factory settings as follows:
Turn the unit off.
When the power is on, wait for more than 30 seconds after
the power turned off.
Press the POWER button while holding down the STOP
button.
Release the STOP button when “Setup CLR” appears on the
display. All memories are now erased and the unit returns to
the factory settings.
2
1
POWER
STOP
