I56-3881-001
EB200-01-02
2
10°
10°
RTS151/KEY
1
2
3
4
5
6
T2-3
T2-4
T2-2
T2-1
OPTICAL LINE OF SIGHT
WALL
MOUNTING
SCREW X 4
COVER
SCREW
X 4
WALL
ACCEPTABLE MOUNTING
LOCATIONS FOR REFLECTOR
REFLECTOR
REFLECTOR
Figure 2a: Reflector Mounting Guidelines
Figure 2b: Reflector Mounting Guidelines
Please refer to the relevant kit instructions if the transmitter/receiver is to be
mounted onto the 6500-SMK/BEAMSMK or 6500-MMK/BEAMMMK allowing
more flexibility for cable entry.
Figure 1: Transmitter/Receiver Wall Mounting
The reflector is mounted directly to the wall using all four of its mounting holes,
one in each corner. The reflector must be mounted such that the plane of the
reflector is perpendicular to the optical line of sight to the transmitter/receiver
unit. The maximum tolerance for non-perpendicular mounting locations is
10°. If this tolerance is not possible, then the MMK should be used, see MMK
instructions for mounting details.
10° MAXIMUM
Figure 3: Detector Terminal Connections
FAULT N.C. FAULT COM
REMOTE TROUBLE OUT
NOT USED
REMOTE ALARM OUT
AUX (-)
TEST INPUT
RES
ET INPUT
POWER IN (+) POWER IN (-)
POWER OUT (+) POWER OUT (-)
ALARM N.O. ALARM COM ALARM N.O. ALARM COM
ALARM LIMITING RESISTOR ALARM LIMITING RESISTOR
SCHOTTKY DIODE (A) SCHOTTKY DIODE (K)
Figure 4: RTS151KEY Wiring
SEE RTS151KEY INSTALLATION INSTRUCTIONS
FOR ELECTRICAL RATINGS OF RTS151KEY
REMOTE ALARM
OUTPUT
AUX (-)
TEST INPUT
RESET INPUT
WIRING
Note: All wiring must be installed in accordance with local requirements.
Warning: Before working on the system, notify the proper authorities
that the system is undergoing maintenance and will be temporarily out of
service.
Wiring connections are made to pluggable terminal blocks, which can accept
wire sizes from 0.3mm² to 3.2mm². For best results screened cable should be
used. Refer to the control panel instructions for cable type limitations
EB-6500R / EB-6500RS
1 2 3 4 1 2 3 4
1 2 3 4
1 2 3 4 1 2 3 4
T3
T2
T1
T4
T5
Signal Name
Terminal Normal State
Active Comment
State
Reset Input
T2-4
High impedance 0V
Momentarily connect
to
Aux- to operate
Test Input
T2-3
High impedance 0V
Momentarily connect
to
Aux- to operate
Aux-
T2-2
0V
-
Internally connected to
Power -ve
Remote Alarm Out T2-1
High impedance +24V
Via 2.2k ohms current
limit resistor
Remote Fault Out T3-3
High impedance +24V
Via 2.2k ohms current
limit resistor
Table 0: Use of Input – Output Signals
WARNING
All INPUT and OUTPUT signal terminals are active LOW (0V)
Do not connect any other voltage to these terminals or
serious damage to the product may result.