12/11/2020
Copyright © 2020 ESL Vision, LLC. All rights reserved. Rev:
OCCUPANCY
SENSOR
9OCC-LV — Programming
PAGE 2 OF 3
Remote Control Programming:
The ESL-REM-100 (Sold Separately) can be use to program the 9OCC
remotely. With a range of 50ft this allows for the flexibility to re-program
for any reason, at any time. Please see REM-100 spec sheet and/or
instruction guide for more detailed information.
DAYLIGHT SENSOR VALUE CONVERSIONS
10 = 0.93 footcandles
30 = 2.97 footcandles
50 = 4.65 footcandles
100 = 9.29 footcandles
300 = 27.87 footcandles
500 = 46.45 footcandles
DEFAULT SETTINGS
Brightness: 100%
Sensitivity: 100%
Hold Time: 15min
Photocell Disabled
Stand-by Dim: 30%
Stand-by Time: +∞ No Shut-Off
Button Operation:
ON/OFF – disables the sensor for a constant on or off position. To enable the sensor, press AUTO.
AUTO – press to start the sensor with the previously used settings. This must be used to utilize the
sensor’s capabilities.
RESET – return to the default settings.
TEST – select sensitivity thresholds and press and then hold for two seconds. This will disable the
standby time and daylight sensor in order to check the other settings. To exit, press
AUTO.
ARROWS – use to make selections on the LED selectors. Press OK to keep the displayed selections.
OK – use to register selections or to clear selections when changing or viewing MODES
DISPLAY – show the last settings that were uploaded to the sensor or the current selections on the
remote’s LED indicators.
SEND – upload and activate the current selections. The light will turn on and off to confirm. Changing the
remote settings will not change the sensor settings without pressing
SEND.
MODES – save preset parameters by using the MODE buttons.
TO SET
:
Press
MODE button on remote. LED indicators will display the current settings. Use arrows to change
each parameter. Press
OK to save the settings to the selected MODE. To activate the settings, aim
remote at sensor and press
SEND.
SMART PHOTOCELL SENSOR – off by default. When enabled, the light will be controlled by the
photocell only, and the occupancy settings will be disabled. If the ambient light is less than the minimum
threshold, the light will remain on,
even if there is no activity. If the ambient light is more than the
maximum threshold, the light will remain off,
even if there is activity in the space.
TO SET:
Either press
DISP or select a MODE to program. Use the ARROWS to select each setting. Set
STAND-BY TIME to (+∞). Press . By default, the DAYLIGHT SENSOR will highlight 10 and 300, with
a
DIM setting of 10%. Select the minimum threshold (10, 30 or 50) and the maximum threshold (100,
300 or 500). Change
DIM level to desired percentage. Press SEND.
LED Indicators:
BRIGHTNESS – select a level to determine the maximum lumen level at full power.
SENSITIVITY – determines how reactive the sensor will be to movement. Range and sensitivity will vary based upon the
sensor installed.
HOLD TIME – the duration that the light will remain on without detecting movement before dimming or turning off.
DAYLIGHT SENSOR – uses the photocell to adjust the LED output in conjunction with the ambient light to provide consistent
lighting regardless of environmental changes. Select the
EYE to use a value based on the current ambient light. The
numbered values correspond to the footcandle conversions listed below. The
SUN disables the photocell and will run the
programmed settings regardless of ambient lighting.
STAND-BY – DIM will determine the maximum lumens to be used when there is no activity detected. A setting of 0% will keep
the light from dimming.
TIME will determine how long the light will remain at the dimming level before shutting off completely.
Setting the time to will make the light remain on.
