Page
3
/
3
Step four—continue. Press “Continue”
button on master controller, other players can press push
button and answer quiz in the same way.
Step five—stop. Press “Stop”
button on master controller, all buzzer lights will turn to red, all players
can’t press buzzer buttons any more.
(Repeat above steps can start a new activity).
Step six—Power off. Press “Power”
button on master controller. All buzzers will power off accordingly.
(Cube buzzer and Tower buzzer press power switch to power off)
4.
Note and trouble shoot
○
1
If the buzzer brightness is not obvious, please replace battery or recharge.
○
2
If the buzzers are red and green, light flashes, means the buzzer is searching signal. If the buzzer is always
searching signal, please check the master controller is on.
○
3
If the master controller can’t control the buzzer, please program the buzzer with master controller. (See
below for how to program.)
5.
Other features--Set Max ID No. and Set ID No.
Note: Max ID and ID No already set by factory, if need change it, please follow below steps.
○
1 Set Max ID No.
Press “Mode”
button on master controller, switch to Set Max Id mode(the arrow in LCD screen point
to Set Max Id) and press “Previous No.“
/ “Next No”
button to select Max number(1-50) , and
then, press “Start”
button, and then OK.
○
2
Set ID No.(Program)
Press “Mode”
button switch to set Buzz Id (the arrow in LCD screen point to Set Id No.), and press
“Previous No.“
/ “Next No”
button to select the number, and then, press “Start”
. At
the same time, hold press push button and “B” button on buzzer till the buzzer green light flashes, and the
master controller display “ok”.
(Remark: For cube buzzer and tower buzzer, there is no “B” button, so, the Set ID No method is hold press
push button and turn on the power button.)
6.
How to use Judge Voting Features (Note: this feature is customize, not normal buzzer.)
○
1
Turn on system. Press “Power”
button on master controller and press push button on buzzer to open
the system, the buzzer red light will come on. (For cube buzzer and tower buzzer, turn on the power switch)
○
2
Start, Press “?”
button for start, all buzzers will turn blue, the judges can press the push button
for voting. After pressing the push button, the buzzer light turns to red.
○
3
Stop, Press “Stop”
button for stop voting. All buzzers lights will turn off.
