to be
fulfill
ed.
The cooker hood must be placed at a minimum distance of 65cm above
the cooking surface of a hob.
Cupboard mo
unti
ng installa
ti
on:
1. Drill a 130mm diameter and four
3.5mm diameter hole as below
picture.
ATTENTION
: If your cooker hood
works at circula
ting
-air mode, it is
not necessary to drill 130mm
diameter hole.
2. Use the 4 screws to
fi
x the cooker
hood to a kitchen cupboard .Check
that your
fi
xings are correctly
located, by temporarily
fitti
ng the
cooker hood. If correct,
fi
t the unit
into pos
iti
on. Tighten the screws if
necessary.
Wall moun
ti
ng installa
ti
on:
1. To mount on the wall, drill two
10mm diameter holes 538/
675/
696mm
with the vent hole on the top of the
cooker hood in the middle as below
picture. Make sure the hood is aligned
directly over the hob.
2. Insert two plas
ti
cs wall plugs
(supplied) into the holes.
3. Insert two screws into the upper two plas
ti
c wall plugs and
tig
hten
them leaving 3mm protruding from the wall.
4. Mount the cooker hood onto the two screws and mark the bo
tt
om two
screw pos
iti
ons.
5. Remove the hood and drill the bo
tt
om two screw holes and Insert the
plas
ti
c wall plugs.
6.
Mount the hood on the top screws, Insert the bo
tt
om screws and fully
tigh
ten all the screws.
130
480/
675/
696
110
100
180
538/
675/
696
EN-8
