3
ASSEMBLY
Q CRANK TABLE BASE
STEP 1
With the table top facing down on a soft, clean surface, arrange the cross channels and top supports
as shown.
• Positioning does not need to be exact
at this time.
• Mounting tabs on cross channels face
inward, toward each other.
• Holes on the top supports are offset
to the rear.
STEP 2
Use a 5mm Allen key to loosen the M10 set screws on the
cross channels (two on each side of center).
STEP 3
Adjust the cross channels to their approximate final
lengths, as shown.
• Center the inner piece in each cross channel.
STEP 4
Attach the side legs to the cross channels and top
supports with six M8x12 screws per leg.
• Use a 5mm Allen key.
• Two screws attach to each cross channel and
two screws attach to the top supports.
Top
Support
Cross Channel
Mounting Tab
Loosen
Set Screws
Center
Inner Piece
M8x12
