M50Q 230VAC series Motor
Quick Setup
v4.7
www.elec-solutions.com
© 2013 Electronic Solutions, Inc.
Page 2 of 4
Power-Up the M50Q
The M50Q series motor includes a keyed 3-conductor AC power connection in the head end of the motor.
Securely connect the included AC Power Cord (PC M40/50 UNIV) to this connector. Installer shall
connect appropriate AC power plug to blunt-cut end.
Motor Configuration
Set Motor Limits:
When power is first applied to a factory default motor, the motor
is in “Set limit mode.” The mode is identified
by a flashing
RED
LED on Button 1 and a flashing
GREEN
LED on Button 2.
1. To set the CCW limit, press either Button 1 (CCW motion) or Button 2 (CW motion), to operate the
motor to the desired CCW limit.
2. Once the desired CCW limit position has been reached, press and hold the Center Button first and then
also press and hold Button 1 (
flashing
RED
) until the
RED
LED turns off and the Center Button
YELLOW
LED lights solid (
approx. 2 seconds
) then immediately release both buttons to set the CCW
limit.
3. The
YELLOW
LED lights solid for three seconds to acknowledge the “Set CCW limit to here” operation,
then the motor go
es into “Set CW limit mode” and the
GREEN
LED on Button 2 will be flashing.
4. Press either Button 1 or Button 2 to operate the motor to the desired CW limit.
5. Once the desired CW limit position has been reached, press and hold the Center Button first and then
also press and hold Button 2 (
flashing
GREEN
) until the
GREEN
LED turns off and the Center Button
YELLOW
LED lights solid (
approx. 2 seconds
) then immediately release both buttons to set the CW
limit.
6. The
YELLOW
LED lights solid for three seconds to ackno
wledge the “Set CW limit to here” operation.
7. Both motor limits are set and all LEDs are off.
Clear both Limits:
1. Press and hold the Center Button until the
YELLOW
LED lights solid (
approx. 10 seconds
) then release
the Center Button.
2. The LED in Button 1 begins flashing
RED
and the LED in Button 2 begins flashing
GREEN
. See "Set
Motor Limits" above.
Clear CCW Motor Limit:
1. Press and hold the Center Button first and then also press and hold Button 1 until the Center Button
YELLOW
LED lights (
approx. 2 seconds
) and then turns off (
approx. 3 seconds later
) then release both
buttons.
2. The LED in Button 1 begins flashing
RED
. See "Set Motor Limits" above.
Clear CW Motor Limit:
1. Press and hold the Center Button first and then also press and hold Button 2 until the Center Button
YELLOW
LED lights (
approx. 2 seconds
) and then turns off (
approx. 3 seconds later
) then release both
buttons.
2. The LED in Button 2 begins flashing
GREEN
. See "Set Motor Limits" above.
Adjust either Motor Limit:
1. Press either Button 1 (CCW motion) or Button 2 (CW motion), to operate the motor to the desired
position.
2. Once the desired limit position is reached, press and hold the Center Button first and then also press
and hold the appropriate button
— Button 1 (CCW limit) or Button 2 (CW limit) — until the
YELLOW
LED lights (
approx. 2 seconds
) then immediately release both buttons to set the corresponding motor
limit.
