September 2013, rev A
© 2013 Electronic Solutions, Inc.
Page 1 of 4
M50Q 230VAC series, v4.7
Motor
Quick Setup
Electronic Solutions, Inc.
1355 Horizon Avenue
Lafayette, CO 80026 U.S.A.
www.elec-solutions.com
Tel: (303) 469-9322
Introduction
This document explains how to set motor limits (end positions) and how to connect the low voltage data cables
to an M50Q series motor. Refer to the
M50Q 230VAC Specifications
document for technical details.
Products
M50Q 230VAC 50Hz series motors
—M50Q 626B, M50Q 1530B
NOTE
: M50Q
part numbers ending with “A” are 120VAC and those ending with “B” are 230VAC.
Before You Start
On power-up: LEDs will blink
GREEN
YELLOW
CW is clockwise rotation looking at the motor from the head end, CCW is counterclockwise.
Be sure the motor is connected to continuous AC power.
An M50Q series motor ships from the factory with a randomized RQ address between C00 and ZZZ and no
limits set.
The M50Q series motor has a 3-conductor, keyed AC power connection in the motor head for connecting the
included AC power cord, PC M40/50 UNIV.
The M50Q series motor has a 5-conductor, keyed low voltage, data connection (RQ Bus and RP Bus) for
use with the CBL 6 FT QE QM, CBL 1 FT QE QM, or RE 1 FT QM, each sold separately. This cable must be
connected after the AC power connection is in place and AC power is applied.
The M50Q series motor has a 3-conductor, keyed low voltage, manual input (dry contact) connection for use
with CBL 6 FT DM, sold separately. This cable must be connected after the AC power connection is in place
and AC power is applied.
The M50Q series motor has three clear buttons with internal LEDs:
o
Button 1,
RED
LED button, with one groove, operates the motor counterclockwise [CCW].
o
Button 2,
GREEN
LED button, with two grooves, operates the motor clockwise [CW].
o
Center Button,
YELLOW
LED button with no groove, used to set and clear motor options.
If any button is pressed while the motor is moving, the motor will stop.
Use an SP1E3Q when connecting more than two RQ-enabled motors (M40Q or M50Q).
Refer to the
M40Q and M50Q Typical Wiring Diagram
on page 4 for an example of wiring.
