IVX 128 Plus upgrade guide
3
Procedure 2: Using Procomm Plus to perform the upgrade
1.
Insert the IVX 128 Upgrade CD-ROM into your PC’s CD-ROM drive.
2.
Use Procomm Plus to connect to the system using baud rate of 38,400 bps with no parity, 8 data
bits, 1 stop bit and software flow control.
3.
Press the
Enter
key. A
Password
prompt will be displayed.
4.
Type the installer password and press
Enter
. The main menu will now appear:
/***********************************************\
| REMOTE OPERATIONS |
| --------------------------------------------- |
| 1 - Receive Software or Prompts (Disconnect) |
| 2 - Receive software/Prompts (Stay connected) |
| 4 - Display installed program versions |
| 8 - Disconnect |
| 9 - Exit this command |
\***********************************************/
Enter your choice from the menu:
5.
Press
4
and
Enter
. The contents of each slot will be displayed. Note which slot (2 or 3) is empty or, if
both slots are occupied, which has the oldest (lowest number) version.
6.
Press
2
and
Enter
. A new menu will appear:
/*********************************************\
| RECEIVE SOFTWARE & PROMPTS |
| ------------------------------------------- |
| 2 - Store Program in Slot 2 |
| 3 - Store Program in Slot 3 |
| 4 - Standard Prompts |
| 8 - Disconnect |
| 9 - Exit this command |
| 0 - Return or press the ENTER key |
\*********************************************/
Enter your choice from the menu:
7.
Enter the number of the slot you noted in step 5 and press
Enter
. A prompt to
Enter Program
Release Number
will appear:
/*****************************************************************\
| Enter Program Release Number, a blank space, and Execution Code |
| Execution Codes: 1=At first idle |
| 2=At midnight |
| 3=On the first power cycle |
| (Example: 2.7.1 1) |
| e to exit this command OR d d to disconnect |
\*****************************************************************/
Enter:
8.
Type in 1.10.8 3 (i.e., the conversion program version, followed by a space, followed by execution
code 3)and press
Enter
.
9.
Confirm your entry by typing
Y
and pressing
Enter
.
10.
A message will appear: “System is ready to receive program into Slot x . . .”
11.
From the Procomm Plus menu, select
Data
, then
Send File
. The
Send File using
window will appear.