5
ASSEMBLY
ALL-FLEX
™
3 LEG ELECTRIC TABLE BASE
STEP 6
Attach the two-piece side top supports. One piece is attached to the frame; the other piece is separate.
• Insert the separate piece of the top support into the top support attached to the frame.
• Align the holes on the inserted piece with the rear set of two holes on the integral top support if the table
depth is less than 30" (76cm). Align the holes with the front set if the table depth is 30" or more.
STEP 7
Change the length of the adjustable feet, if necessary.
• The length of the feet may be either 22" (55.9cm) or 28"
(71.2cm). The feet are shipped in the 28" length. They
should be changed to the shorter length if the work
surface depth is less than 28".
• To change the length to 22":
A.
Remove the two plastic Phillips screws holding
the adjustment plate in place.
B.
Use the 5mm Allen key to remove the four hex
head screws.
C.
Use the 3mm Allen key to loosen the two set
screws.
D.
Slide the feet to the 22" length. Reinstall the four
hex head screws and tighten the set screws.
• Store unused adjustment plates in the brackets
attached to the frame, securing them with the two
plastic Phillips screws.
30" Table
Use Front Set of Holes
Two-Piece
Top Channel
4mm
Allen Key
24" Table
Use Rear Set of Holes
22"
Adjustable
Length
28"
5mm
Allen Key
3mm
Allen Key
Set
Screws
A
B
C
D
Store
Adjustment
Plates
