All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH, ESERA-Automation 2020
www.esera.de
11108 V1.0 R1.0 Manual
Page 1 of 4
Art.No. 11108
User Guide
5-fold distribution module for
1-Wire Temperature Sensors
1-Wire Extension 5
Features
Distributor for 1-Wire Temperature sensors with
RJ12 connectors
5 outputs for temperature sensors
Housing for wall mounting
Connection via screw plug connector
Improvement of the signal quality through
additional electronics
Typical areas of application
Temperature monitoring of heat storage tanks
Heating control, building management system and
air conditioning
Monitoring of frozen goods
Quality assurance
laboratory equipment, scientific devices
Industrial temperature measurement
1
Introduction
Before you start to install the 1-Wire Extension 5 and put the device into operation, please read this manual
carefully until the end, especially the section of the safety instructions.
2
Product Description
The 1-Wire Extension 5 is designed as local distributor for 1-Wire temperature sensors with RJ12 connector.
In combination with the different cable lengths of the temperature sensors a simple and fast cabling of up to
5 temperature sensors is possible, e.g. in the area of a heating system or industrial plant.
The design of the outputs with RJ12 sockets eliminates errors compared to distributors with clamp
connections or "luster terminals".
The cable temperature sensors and the 1-Wire Extension 5 form a coordinated cabling system.
As further system components for the 1-Wire network, we recommend the use of a
1-Wire Hub II
as power
supply,
1-Wire bus coupler
or
1
-Wire Controller
1
as coupling to the control computer.
No software is required for this module.
Illustration similar ,module without LED displays