ESE ES-102, Operation And Maintenance Manual, Page: 14 / 22

Page 14
QTY DESIGNATION DESCRIPTION PART NUMBER
1 T1 TRANSFORMER P6465
1 D-SUB CONNECTOR 9 PIN MALE D-SUB
1 D-SUB CONNECTOR 9 PIN FEMALE D-SUB
1 D-SUB HOOD 9 PIN D-SUB HOOD
3 BNC BNC (UG-1094)
1 XLR XLR-3-32 (M)
1 ANTENNA ANTENNA FOR GPS
1 GPS ANTENNA CABLE GPS ANTENNA CABLE
1 CLIP AND LENS CLIP & LENS FOR LED
1 F1 FUSE 1/2A FUSE
1 FUSE HOLDER HTA FUSE HOLDER
1 3 WIRE BUSHING 3 WIRE BUSHING
1 LINE CORD 3 WIRE LINE CORD
1 CASE AND HARDWARE ES-102
QTY DESIGNATION DESCRIPTION PART NUMBER
1 (ANT) EMI ANTENNA EMI ANTENNA
1 (ANT) EMI ANTENNA CABLE EMI ANTENNA CABLE
1 (BBU) PC BOARD ES-1424P
1 (DC) FUSE 2 AMP FUSE
1 R19 (HR) RESISTOR 2.2K 1/4 W
1 D3 (HR) DIODE 1N4003
1 Q1 (HR) TRANSISTOR PN2907
1 K1 (HR) RELAY 1A5A RELAY
1 (J) TRANSFORMER P8705/SSA5-6.3/230
1 (K) PC BOARD ES-110M12
1 (K) M12+ TIMING RECEIVER P283T12T12
1 (UL) TRANSFORMER AA-061A5-206
1 (UL) UL POWER PLUG UL PWR PLUG
1 (45 nS) M12+ TIMING RECEIVER P273T12T17
IF COMPONENT REMOVAL IS REQUIRED, WE RECOMMEND REMOVING ALL SOLDER USING A 35W OR SMALLER
SOLDERING IRON AND SOLDER WICK TO PREVENT DAMAGE TO THE PRINTED CIRCUIT BOARD.
ALL INFORMATION CONTAINED IN THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
CHASSIS COMPONENTS
OPTIONAL COMPONENTS
ES-102 PARTS LIST (CONTINUED)
NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS A DIGITAL
DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE
PROTECTION AGAINST HARMFUL INTERFERENCE WHEN THE EQUIPMENT IS OPERATED IN A COMMERCIAL
ENVIRONMENT. THIS EQUIPMENT GENERATES, USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF
NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION MANUAL, MAY CAUSE HARMFUL
INTERFERENCE TO RADIO COMMUNICATIONS. OPERATION OF THIS EQUIPMENT IN A RESIDENTIAL AREA IS
LIKELY TO CAUSE HARMFUL INTERFERENCE IN WHICH CASE THE USER WILL BE REQUIRED TO CORRECT THE
INTERFERENCE AT HIS OWN EXPENSE.