Installation
CPCI-HD/2
Hardware Manual • Doc.-No.: C.2318.21 / Rev. 1.0
Page 11 of 13
3. Hardware Installation
Attention!
Electro-static discharges may cause damage to electronic components. In order to avoid this please
make sure to follow the steps below
before
touching the CPCI module:
@
Switch off the power supply of your CompactPCI system, but leave it connected to mains.
@
Now touch the metal case of the computer to discharge yourself.
@
Even your clothes must not touch the CPCI module.
Installation Steps:
1.
Switch off your CompactPCI system and all connected peripheral devices (monitor, printers,
etc.).
2.
Discharge yourself as described above.
3.
Disconnect the CompactPCI system from mains.
4.
Select an open 3U-CompactPCI bus position and insert the CPCI-HD/2 module into the slot
selected. The module can be inserted into any 3U-slot.
5.
Attach the module by means of the front panel screws.
6.
Connect the CompactPCI system to mains again.
7.
Switch on the CompactPCI system and the peripheral devices again.
8.
End of hardware installation.
9.
Now you can configure the HDD and the CompactFlash. Please read the documentation of
your operating system for more information.
