Version CAN-PC104/331-2-Micro-Match
5. Version CAN-PC104/331-2-Micro-Match
5.1 Overview
This version of the PC104-module has got an AMP-Micro-Match socket instead of a DSUB9-CAN-
connectors. The socket is so small that it does not protrude the PCB, even if it is connected to a
plug. This is of great advantage, if the module is to be used in a narrow case.
An adapter cable is contained in delivery of CAN-PC104/331-2-MicroMatch (Order No.
C.2012.09). The cable with a length of 15 cm converts from micromatch connector to DSUB9. The
DSUB-connector of the adapter cable corresponds to the standard assignment of a 9-pin DSUB-
connector for CAN (see DSUB9-CAN-connectors).
NOTICE
The micromatch connector is
not protected against wrong polarity
!!
In order to prevent damage to property, the connecting cable must always be connected
as shown in the figure below!
Figure 5:
View of CAN-PC104/331 Micro-Match
If you want to make the adapter cable yourself, you require the following information:
The AMP-socket used on the board has got the following designation:
AMP Micro-Match, FL, 10-pin, No. 8-215079-0
Page 18 of 32
Hardware Manual • Doc. No.: C.2012.21 / Rev. 1.6
CAN-PC104/331
