Installation
PMC-DVI
Hardware Manual Rev. 1.0
7
2. Hardware Installation
Because the PMC-DVI module can be inserted to various circuit boards, the carrier system is described
as ‘computer’ in the following.
Attention!
Electro-static discharges may cause damage to electronic components. In order to avoid this please
make sure to follow the steps below
before
touching the CAN-module:
@
Switch off the power supply of your computer, but leave it connected to mains.
@
Now touch the metal enclosure of the computer to discharge yourself.
@
Even your clothes must not touch the CAN-module.
Installation:
1.
Switch off your computer and all connected peripheral devices (monitor, printers, etc.).
2.
Discharge yourself as described above.
3.
Disconnect the computer from mains.
If the computer is tightly connected to mains and does not have any flexible mains power line,
disconnect the mains via the fuse. Make sure that the fuse cannot be switched on unintentionally.
4.
Open the enclosure.
5.
Insert the PMC-DVI module to a suitable carrier board.
6.
Install the carrier board in the system.
7.
Close the enclosure again
8.
Connect monitor, mouse and keyboard. An adapter for mouse and keyboard is available.
9.
Switch on the power supply of the computer again (power plug or fuse).
10. Switch on the computer, the monitor and the peripheral devices.
8.
End of hardware installation.
9.
Now, you can configure the PS2-interface. For further information refer to the documentation of
your operating system.
