Installation
CPCI-HD
Hardware Manual Rev. 1.0
7
2. Hardware Installation
Attention!
Electro-static discharges may cause damage to electronic components. In order to avoid this please
make sure to follow the steps below
before
touching the CAN-module:
@
Switch off the power supply of your computer, but leave it connected to mains.
@
Now touch the metal case of the computer to discharge yourself.
@
Even your clothes must not touch the CAN-module.
Installation:
1.
Switch off your computer and all connected peripheral devices (monitor, printers, etc.).
2.
Discharge yourself as described above.
3.
Disconnect the computer from mains.
4.
Insert the CPCI-HD module into a free CompactPCI slot.
5.
Attach the module by means of the front panel screws.
6.
Connect the computer to mains again.
7.
Switch on the computer and the peripheral devices.
8.
End of hardware installation.
9.
Now, you can install the HD-drive and the CompactFlash interface. For further information refer
to the documentation of your operating system.
