456500(6501)k1.doc
Operation TM-U950:
Using the Electronic Journal (EJ) Switch to Print Journal Data
1. To select a journal date press and release the
EJ Switch
to the
Switch I
position.
2. Wait for a printout after each EJ switch closure. Pressing the EJ Switch more than once before a printout may
cause you to skip over desired journal dates.
3. The date is displayed as mm/dd/yy format. The printer automatically times out of this mode if no input has been
entered. The first time you initiate this mode, the printer prints a message similar to:
Print Journal data for MM/DD/YY?
4. To move to a prior date, press and release the
EJ Switch
to the
Switch I
position.
5. To print the journal for the selected date, press and release
EJ Switch
to the
Switch II
position.
6. To abort printing journal press and release the
EJ Switch
to the
Switch I
position. “
USER QUIT”
will be printed.
Using the Electronic Journal (EJ) Switch to print partial journal contents from the Current Date to the Oldest Date
(Prints most current to oldest journal data as long as the Switch II is pressed
.)
1. Press and hold the
EJ Switch
to the
Switch II
position, release when the desired amount of data has been
printed.
Note:
If mistake is made then allow printer to automatically “time-out” of this mode (30 seconds) and
start
over
“
TIMED OUT”
will be printed.
Installation (RP310 & TM-T88, Ruby Receipt only) (Jumper 4 only)
1. Log
off
Ruby & Unplug the Ruby power cable.
2. Unplug the serial adapter w/cable along with the power cable from the back of the “OLD’” RP310 or TM-
T88printer. The adapter module and cable will be reused with “NEW” printer.
3. Replacement serial adapter ESCO #0502-0505.
4. Securely cover the end of the power adapter Y cable that was removed from the “OLD” printer with the supplied
Red Cap Plug, this connector of the Y cable is no longer required.
5. Plug and secure the serial adapter and cable removed from the “OLD” printer into the serial connection of the
“NEW” printer.
6. Make sure the printer power switch is in the “OFF” position and plug the AC power cord into the back of the
printer. Plug the “Male” end into a Surge Protector or UPS 120 VAC outlet.
7. Turn the printer power “ON” and initialize the Ruby Terminal, the new printer is now ready to print receipts.
Installation (RP310 & TM-T88, Topaz Receipt only) (Jumpers 2 & 4 only)
1. Log
off
Topaz & Unplug the Topaz power cable.
2. Unplug the serial adapter w/cable along with the power cable from the back of the “OLD’” RP310 or TM-
T88printer. The adapter module and cable will be reused with “NEW” printer.
3. Replacement serial adapter ESCO #0502-0505.
4. Securely cover the end of the power adapter Y cable that was removed from the “OLD” printer with the supplied
Red Cap Plug, this connector of the Y cable is no longer required.
5. Plug and secure the serial adapter and cable removed from the “OLD” printer into the serial connection of the
“NEW” printer.
6. Make sure the printer power switch is in the “OFF” position and plug the AC power cord into the back of the
printer. Plug the “Male” end into a Surge Protector or UPS 120 VAC outlet.
7. Turn the printer power “ON” and initialize the Topaz Terminal, the new printer is now ready to print receipts.
