ESCO Technologies ETS-Lindgren HI-6006, User Manual

Page: 78 / 140

78 Series H-491198-01 Battery Charger ets-lindgren.com
D
ISCHARGING A
B
ATTERY
To discharge the batteries:
1. Make sure the probe is off or the batteries will not charge.
2. Connect the battery charger to the electrical mains, and then plug the
charger output into the battery charger connector on the probe.
3. Press the DISCHARGE button on the battery charger. The batteries
will fully discharge, and then fully recharge. The total time required to
discharge and recharge is approximately seven hours.
Battery Charger Specifications
The battery charger may be powered by standard line voltage (110
–240 VAC,
50
–60 Hz) or by an optional automobile cigarette lighter plug (12.5 VDC).
NiMH Battery:

4 AAA batteries, rechargeable
NiMH (rapid charge cells,
1.2 volts/cell)

ETS-Lindgren Part #400038
(quantity required = 4)
Power
Main: IEC filtered AC power input module
110-240 VAC, 500 mA max,
50-100 Hz
Alternate: Automobile cigarette lighter to 2 mm
power plug adapter cord, 12.5 Vdc,
100 mA
Fuses: 250 volt, 1.0 Amp, Type T
(5 mm x 20 mm)