FIGURE 2
DETAIL B
3
If installing to the back of a
basketball pole
continue onto
Step 2 on
this page
. If mounting to a
Wall
skip this page and continue on
page 4
.
2. Clean the flat side of the mounting bracket surface with alcohol. Peel
one side of the mounting
Tape
(
#6
) and adhere the to the
Flat
part of
the
Mounting Bracket
(
#2
)as shown in
Detail A
.
3. Clean mounting location surface with alcohol. Peel the other side of
the mounting tape and adhere mounting location. See
Detail B
.
4. Install self-drilling screw using 5/16” Hex Socket Driver and cordless drill.
When 5/16” Hex Driver makes contact with Mounting Bracket finish
tightening screw with Philips Screwdriver. Do not over tighten. See
Detail C
.
3
Back of pole
NOTE:
Holes must be in the
Vertical
position as shown
before adhering to pole.
NOTE:
Holes in the Mounting Bracket (
#3
) must be in the
Vertical
position as
shown in
Detail B
before
adhering Mounting Bracket to the pole.
6. When the Mounting Bracket is completely adhered to the pole, attach the
Ball holder assembly with two Screws (
#4
). See
Figure 2
.
DETAIL A
6
Flat Surface
Peel
3
3
4
NOTE:
Tighten
until secure, but
DO NOT
OVER-
TIGHTEN.
DETAIL C
7
5. If self-drilling screw is not used Mounting Bracket must be clamped in place
for 24 hours before attaching Ball Holder.
