6
8. As shown, insert one end of the fiberglass rod into the triangular pocket on the FRONT upper
outside corners of the net. The rod will then remain on the front of the net until it reaches the
second
diagonal square from the lower inside corner as shown in
Detail 8
. Please push it
though this hole and down into the fiberglass rod pivot connector. Then carefully take the
fiberglass tube sleeve and slide it over the pivot connector as well. Do this for both sides.
Yard Guard
Detail 6
*Rim
not sho
wn
for clar
ity.
8
(Right)
7
(Left)
4L-8156-00
WAR
NING
!
NOTE
: Make sure
Warning Label and
artwork face
FRONT.
7. Assemble both fiberglass rods (#5) and then
carefully push them through the Vinyl sleeves
(#9). See
Detail 6
and
Detail 7
.
5
5
9
Figure 4
Second
diagonal
square
Detail 7
Detail 8
!
