Figure 11
17.
Attach of Upper Arms (#6) to Top Pole (#3), as shown
in
two spacers (#8) and one lock nut (#4).
Note: Tighten bolts snug but, do not over tighten. Board
Arms must pivot freely.
18.
Insert two Tube Plugs (#9) into open ends of Upper Arms
(#6). It may be necessary to use a rubber mallet to tap plug
in.
Note:
Tube plugs may be pre-installed by the factory.
19.
Slide Actuator Crank (#35) onto shaft on the bottom of
Actuator (#16). Line up hole in shaft with hole in Actuator
Crank and insert Pin (#34) to secure. See
Figure 12
.
20.
To aid in the assembly of the backboard, lower the backboard,
by turning the Actuator Crank, until the lower arm makes
contact with Stop Spacer (#10).
Figure 12
6
7
18
8
18
4
9
3
16
Stop Spacer
(#10)
35
34
Figure
11
, using a bolt (#7), two flat washers (#18),
BA
CK
SID
E
12
