User Manual
06
Installation
UNPACKING THE WASHING MACHINE
Unpack your washing machine and check if there is any
damage during the transportation. Also make sure that all
the items in the attached bag are received.
If there is any damage to the washing machine during the
transportation, or any item is missing, please contact the
local dealer immediately.
DISPOSE THE PACKING MATERIALS
The packing materials of this machine may be dangerous to
kids. Please dispose them properly and avoid easy touch by
kids. Please dispose the related packing materials according
to the relevant local regulations. Please do no throw the
packing materials away together with the other daily living
rubbishes.
REMOVE TRANSPORT BOLTS
Before using this washing machine, transport bolts
must be removed from the backside of this machine. Please
take the following steps to remove the bolts:
1. Loosen all bolts with spanner and then remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
→
SELECT THE LOCATION
Before installing the washing machine, the location
characterized as follows shall be selected:
→ Rigid, dry, and level surface (if not level, please make it
level with reference to the following figure “Adjust Leg”)
→ Avoid direct sunlight
→ Sufficient ventilation
→ Room temperature is above 0 C
→ Keep far away from the heat resources such as coal or
gas. Make sure that the washing machine will not stand
on power cord.
→ Do not install the washing machine on the carpet floor.
ADJUST LEG
1. When positioning the washing machine, please first
check if the legs are closely attached to the cabinet.
If not, please turn them to their original positions with
hand or spanner and tighten the nuts with spanner.
2. After positioning the washing machine, press four
corners on top cover of washing machine in sequence.
If the washing machine is not stable when being
pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing machine.
Loosen the lock nut with spanner and turn the leg with
hand until it closely contacts with the floor. Press the leg
with one hand and fasten the nut closely to the cabinet
with the other hand.
→
4. After being locked properly, press four corners again to
make sure that they has been adjusted properly. If it is
still unstable, it has to repeat Steps 2 and 3.
5. Put a solid cylinder (e.g. pop cans) oppositely on the
top cover of the washing machine from in the left, right,
front and back directions. If the cylinder keeps stable,
the washing machine is positioned level. If it rolls, the
washing machine is positioned unlevel. The rolling
direction is the direction of lower ground surface. Then,
the two legs in this direction shall be raised at the same
time until the washing machine is level. Steps 1–3 are
repeated to make the bottom legs closely against the
ground and the nuts shall be locked tightly.
CONNECT INLET PIPE
Connect the inlet pipe as indicated in the figure. For the
model which has hot valve , please connect the hot vale to
hot water tap. Energy will decrease automatically for some
program.
→
