Esatto EDW6SL, User Manual

Page: 17 / 24

Page:
17
User Manual:
CARING FOR THE DISHWASHER
→ The control panel of the dishwasher can be cleaned using a slightly dampened cloth.
After cleaning, ensure it is dryed thoroughly.
→ To clean the internal edge of the door, you should only use a soft, damp cloth with warm
water. Avoid using any spray cleaners as these can penetrate into the door lock and
electrical components.
CLEANING THE SPRAY ARMS
→ It is necessary to clean the spray arms regularly for hard water chemicals will clog the
spray arm jets and bearings.
→ To remove the upper spray arm, hold the nut and rotate the arm clockwise to remove.
→ To remove the lower spray arm, pull the spray arm upwards (as per the diagram below).
→ Wash the arms in warm soapy water and use a brush to clean the jets. Replace the spray
arms after rinsing thoroughly.
GENERAL CARE INSTRUCTIONS FOR YOUR DISHWASHER
→ After every wash, leave the door slightly open so that moisture and odours are not
trapped inside.
→ Before performing maintenance or cleaning, always switch off at the power outlet and
remove the plug.
→ To clean the exterior and rubber door seals of the dishwasher, never use solvents or
abrasive cleaning products. Warm soapy water should always be sufficient, or for
stubborn stains only use specialty cleaning products specifically made for dishwashers.
→ When your dishwasher won't be used for a long period of time, it is recommended that
you run a wash cycle with the dishwasher empty and then leave the dishwasher door
slightly open. Also unplug the dishwasher from the power socket.
→ When moving the appliance, always try to ensure it is kept in the vertical position. If
absolutely necessary, it can be positioned on it's back.
→ One of the factors that can cause odours to form is residual food that remains trapped in
the seals. Periodic cleaning with a soft damp cloth (as described above) will prevent this
from occuring.