Page:
5
User Manual:
Installation Instructions
BEFORE USING YOUR BAR FRIDGE…
→
Remove the exterior and interior packing.
→
Before connecting the bar fridge to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
→
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION LOCATION:
→
When selecting a position for your bar fridge you should make sure that the floor is level,
and that the room is well ventilated with an average room temperature of between 16°
and 35°.
→
Always avoid locating your bar fridge near a heat source, such as a heater.
→
Also avoid direct sunlight as it may increase the electrical consumption.
→
Extreme cold ambient temperatures may also cause the unit not to perform properly.
This unit is not designed for use in a garage or outdoor installation.
→
Do not drape the unit with any covering.
→
When installing the unit, ensure that 20 cm of free space is left at both sides, 15 cm at the
rear and 20 cm at the top of the unit. This will allow cold air to circulate around the wine
cooler and improve the efficiency of the cooling process.
→
The door can be hinged to open to the right or to the left, depending on what better suits
the location.
→
Please ensure there is adequate space for the door to fully open.
→
Adjust the two levelling feet to ensure that the bar fridge is horizontally and vertically
level.
REVERSING THE DOOR SWING:
Tools Required: Phillips head screwdriver, Flat blade screwdriver and Hexagonal spanner.
→
Start by ensuring the bar fridge is unplugged and empty.
→
Adjust the two levelling feet to their highest position.
→
To remove the door it is necessary to tilt the bar fridge backwards. Rest the fridge against
something solid to prevent it from slipping whilst removing the door.
→
All parts that are removed will be used when re-assembling the door hinge, so ensure
they are all kept safe .
→
DO NOT lay the bar fridge on its back or sides as this may damage the coolant system.
→
This is a two person proceedure.
1
.
Remove the plastic cover from the top door hinge.
2
.
Unscrew the three screws from the bottom bracket and remove the hinge
bracket from the opposite side and place aside.
3
.
Slide the fridge door down approximately 15cm and remove from the top
hinge, lifting the door away from the fridge.
4
.
Remove the two screws from the top bracket and replace the bracket
using the same screws on to the opposite side. Note: You will need to
remove the plastic cover caps from the opposite side first.
5
.
Slide the fridge door back into the top hinge, ensuring that it is the
correct way up. Then screw the bottom hinge bracket into place, securing
the door in place.
6
.
Fit the plastic cover caps and ensure that the door is aligned both
vertically and horizontally, before tightening the bottom hinge. Re-adjust
the levelling feet.
