Esaote MyLabX5VET, Getting Started, Page: 54 / 114

P R E P A R I N G T H E S Y S T E M
MyLab
- G E T T I N G S T A R T E D 4 - 6
B/W Thermal Medical USB Printer housing
Those kinds of printers can be hosted in the lateral storage area.
Procedure
1. Connect both the power and the USB cables to the printer.
2. Insert the printer into the storage area by first introducing the
cables.
3. Switch the printer on.
Auxiliary Monitor
Any auxiliary monitor connected to HDMI type port has not to be used for
diagnostic purposes.
NOTE
The resolution of the auxiliary monitor cannot be lower then the main
display. The system automatically shuts down whenever a lower resolution
is detected.
Monitor Connection Connect the monitor cable to the connector of the rear panel.
Moving and Transporting the System
MyLab
is provided with wheels and handle to allow the user to easily move the
device. The following precautions must be observed:
Moving the system 1. Switch the system off.
2. Engage the wheel brakes by press both pedals fully down.
3. Use the handle lever to center the control panel and move it
to a comfortable height for moving.
4. Turn the mains switch off and unplug the power cord,
wrapping it on the handle to ensure it.
5. Disconnect all external cables, including network and
external devices.
6. Secure all cables, probes and accessories so that they do not
interfere with the wheels.
7. Lock the monitor arm by rotating the lever on the monitor
arm on lock position.
8. Release the wheel brakes and set the steering locks for
comfortable moving.