ESAB Origo Feed 354 P3, Instruction Manual

Page: 25 / 62

5) INSTALLATION
5.1) Receiving the equipment
At receiving an Origo™ Feed 354 remove all the packaging material around the unit and check for possible
damages that could have happened during transport. Any complaints related to transport damage should
be directed to the transport company.
Remove carefully any material that could obstruct the refrigeration air system.
N.B. : In case an Origo™ Feed 354 is not installed immediately, keep it in its
original packaging or store it in a dry and well-ventilated place.
N.B. DO NOT USE THE MAIN SOURCE NEUTRAL FOR EARTH
CONNECTION. :
All the eletric connections should be fitted completely to avoid risk of
sparklings, over heating or voltage slopes in the circuits.
5.2) Working area
Several facts should be taken into consideration when determining the working place of a welding machine,
in order to have a safe and efficient operation. An adequate ventilation is needed for the refrigeration of the
equipment and for the operator's safety.The area should be kept clean.
The installation of any filter dispositive in the environment restricts the air volume available for the machine
refrigeration which can cause overheating to the internal equipment. All guarantee undertakings from the
supplier cease to apply if the customer/user installs any filter dispositive not authorized by the supplier.
5.3) Installation
1) Connect the wire feeder to the power source through the cable of command.
2) Fix the connector to the te power source in the block of connections in the wire feeder.
3) Fix the hose of the gas pressure regulator in the inlet nipple of the rear solenoid valvule of the wire feeder.
4) Install the welding gun (see specific manual)
5) Install the wire.
6) Install the feed rollers according to the type and wire diameter to be used. (see table 5.1 or 5.1.1 from
serial number: A11350002).
TABLE 5.1
Wire type Diameter (mm)
0706963
0706964
0706965
0706966
0706967
0706968
0706969
P/N
Pressure rollers
Solids, steels
Aluminium alloys
Cored wire
--
0.80 - 1.00
1.00 - 1.20
1.20 - 1.60
1.00 - 1.20
1.20 - 1.60
1.60 - 2.40
Note:
Valid for
equipment before
the serial number
A11350002
Origo Feed 354 P3
25