ESAB MultiPower 460 Pulse, Instruction Manual

Page: 14 / 52

14
DESCRIPTION SECTION 2
When using a DuraDrive 4-30 or DuraDrive 4-48 Wire Feeder, the wire feed
speed is displayed in inches per minute (IPM) in the top display when the
PRESET button is pressed and the wire speed adjustment knob on the
wire feeder is rotated. The WFS LED beside the top display meter will light
when the display is showing wire feed speed.
5. VOLTAGE / CURRENT / TRIM
The arc voltage is controlled with this knob when the WELD PROCESS
selector switch is in the MIG position. The Mig arc voltage can be preset
by pressing the PRESET button and reading the arc volts in the bottom
digital display while rotating this knob.
The arc current is controlled with this knob when the WELD PROCESS
SWITCH is in the TIG or STICK position. The welding current can be preset
in amperes by pressing the PRESET button and reading the current (amps)
in the top digital display while rotating this knob. The average weld current
will be displayed during welding.
For MIG PULSE welding, the arc length (arc voltage) is controlled with this
knob. The WELD PROCESS switch is placed in the MIG position and the
mode switch is placed in the PULSE position. The knob should be place at
the 12 o'clock position as the synergic preset for the wire feed speed, WIRE
TYPE and WIRE DIAMETER choosen by the operator using the PULSE
SELECTION switches. The arc length can then be adjusted by turning the
knob clockwise to increase the arc length or counterclockwise to decrease
the arc.
6. PANEL/REMOTE SWITCH
With this switch in the PANEL position, output voltage in the CV mode and
the output current in the CC mode are controlled by adjusting the VOLTAGE/
CURRENT/TRIM knob on the power source control panel to the desired
output. In the REMOTE position, output is controlled using a remote control
device such as a wire feeder, hand control or foot control.
NOTE:
A DuraDrive Wire Feeder is required to
preset wire feed speed.
Figure 2-4. Pulse Control Panel
Preset
Button
Mode
Switch
Panel/
Remote
Current
Voltage
Material Selection
(Pulse)
Wire Diameter
Selector (Pulse)
Weld Process
Switch
Inductance