The HandyPlasma 50 is a compact, completely self-contained plasma cutting
system. As shipped, the system is fully assembled and ready to cut after being
connected to input power and a source of prefiltered compressed air 5-10 bar
(set torch at 118 lt/min @ 5.2 bar). The Handy Plasma 50 package uses the PT-
31XL torch with 50 Amp consumables to deliver cutting power for materials up to
15 mm thick or for severing up to 19 mm thick. Refer to the following paragraphs
for descriptions of the Handy Plasma 50 packages available as well as
performance specifications.
Do not use any torch with this power source other than the ESAB brand
PT-31XL torch. Serious injury may occur if used with any other torch.
See below for ESABs accessories for the cutting torch.
3 INTRODUCTION
3.1 Equipment
List 3.1.1 HandyPlasma 50 Cutting Packages
Each HandyPlasma 50, Plasma Arc Cutting Package P/N 0700157880 includes:
N°1 Power Source HandyPlasma 50.
N°1 PT-31XL* Torch assembly with 8m service lines.
N°1 earth cable 8m length.
N°1 Torch Spare Parts Kit, see list below.
List 3.1.2
PT-31XL* Spare Parts Kit P/N 0558003464 Contents
N° 3 50A Nozzle, P/N (20861)
0558000513
N° 3 Electrode, P/N (20862)
0558000507
N° 1 Swirl Baffle, P/N (20463)
0558000506
N° 1 Long Heat Shield, P/N (36284)
0558000509
N° 1 O-ring, P/N (950790)
0558000514
*PT-31XL Torch Assembly P/N 0558003467 is supplied with the nozzle, electrode, swirl baffle and heat shield
assembled.
(Part numbers in brakets could be found on the explosion drawings inside the torch spare part kit box.)
4
Fig. 3.1.2 PT - 31 spare part list and consumables
GB
INSTRUCTION MANUAL
