6 CONTROL PANEL
0463 641 001
- 26 -
© ESAB AB 2018
within the short arc region (150–200 A). To do thicker than 6 mm plate you need to switch the
power source into Manual MIG mode.
NOTE!
The weld chart indicates up to 6 mm material thickness but does not list the maximum
material thickness capability of all wires in Manual MIG mode. Mild Steel Solid wires
for example may achieve good weld results on up to 12 mm material.
6.1.11
Icon reference guide
Home
Spot time on/off selection
Information
MIG Torch
Spot time on adjustment
Parameters
Flux cored
Parameters
Manual MIG
Percent
MMA
Preflow
The time the
shielding gas stays on
before the welding arc is
started
Smart MIG
Postflow
The time the
shielding gas stays on after
the welding arc is stopped
Lift-TIG
For more information, see
section "Lift TIG operation"
Seconds
Saving
welding programs for
a specific application when in
the Memory Mode
Settings
on user manual
menu
Cancel
