−
7
−
dpb1d1ea
5.1
Location and connection
S
Place the welding power source so that the cooling air in
−
and outlets remain
free.
S
Connect the shielding gas (see fig. on page
7
).
S
Connect the TIG torch and the torch return cable, alternatively the welding and
return cable of the electrode holder (see fig. on page
7
).
S
Make sure the welding power source is connected to the right mains voltage and
that it is properly fused. Connect to earth according to applicable regulations.
Rating plate with connection data is located on the rear of the welding power
source.
The machine is now ready for use.
6
OPERATION
General safety regulations for the handling of the equipment can be found on
page
3
. Read through before you start using the equipment!
6.1
Controls and connections
Central connection
A
Mains switch ON/OFF
H
Mains voltage ON, LED
B
Connection for remote control unit
J
Welding voltage ON, LED
C
Torch connector
L
Error / Overheating, LED
D
Connection for electrode holder (MMA)
M
Flow guard, LED
(Functions when the cooling unit is
connected)
E
OKC connection for TIG torch
N
Connection for shielding gas to the machine
F
Return cable connection
O
Control unit, digital display
G
Shielding gas connection
P
Central connection for TIG torch
N.B.
The positions C and G are dropped when the central connection is used.
GB
