-- 14 --
cra1d1ea
ACCESSORY SET FOR WELDING TITANIUM
Order number, see on page 5.
Welding with the accessory kit for titanium.
1. Cut a hole in the rubber disk (1) so that the rubber rests against the plate at a safe dis-
tance from the arc.
2. Dismount the complete gas shield (2) from the three--point support (3) by means of an
Allen key (4).
3. Adjust the weld diameter and arc length in the normal way (preferably while the tool is
attached to the work piece).
4. Fit the gas shield (2) with the gas connection pointing downwards.
5. Purge the tool with gas to drive out all the air.
6. Tape over the ø8 holes in the outer casing of the tool (6).
dra1b015
