3
PREPARATION & OPERATION
ESAB A20/A30 welding helmets are fully assembled and ready to be used after minor
adjustments. All welding helmets are equipped with a comfortable headgear that can be
adjusted in four different ways:
Install headgear by removing threaded knobs (one at a time) and fasten again after placing
each threaded stud through the larger holes on the sides of the helmet. Rotate the adjustment
knob at the rear of the headgear assembly to fit the users head.
Before commencing work please inspect carefully the welding helmet and ADF for any visible
marks, cracks, pitted or scratched surfaces; damaged surfaces even on protection plates
reduce vision impair protection. If protection plates are scratched, damaged or built up with
spatter please replace.
Welding helmets should not be dropped. Do not place heavy objects or tools on or inside the
helmet as they might damage the components. If used properly the welding filter requires no
further maintenance during its lifetime.
SERVICING AND MAINTENANCE
Only clean the A20/A30 with mild soap and water. Dry with a clean cotton cloth.
Please note the use of solvents is strictly prohibited, as they will damage the mask and filters.
Scratched or damaged visors must always be replaced.
The user must make daily regular checks to ensure no damage is evident. Outer and Inner
Visors are consumables and must be replaced regularly with genuine certified ESAB spare
parts.
We recommend a use period of 2-3 years. The duration of use depends on various factures
such as use, cleaning, storage and maintenance. Frequency of inspections and replacement