11
ROUTINE
MAINTENANCE
Lower the attachment to rest flat on the ground, shut down the engine, relieve the
hydraulic pressure to the attachment, set the park brake, and wait for all motion to stop before leaving
the operator’s seat to perform service of any kind.
It is the operator’s responsibility to make daily inspections of the loader and attachment for damage, loose bolts,
fluid leaks, or anything else that could cause a potential service or safety problem. Preventive maintenance is
the easiest and least expensive type of maintenance.
IMPORTANT:
Bolts can loosen after initial usage. After the first hour of operation check all bolts.
Use No. 2 lithium base gun grease when lubricating
all attachment grease fittings.
Grease the angle pivot bushing every
8 hours
of
operation.
Grease both angle cylinder zerks (if equipped) every
8 hours
of operation.
NOTE:
It may be necessary to angle the blade to the
right to allow easier access to both angle cylinder
zerks.
8
No. 2 Lithium
base gun grease
Clean engine oil
LUBRICATION
