Erskine Attachments 18HDRS, Operator'S Manual

Page: 8 / 36

8
MOUNTING INSTRUCTIONS
8. Connect the hydraulic quick couplers from the
attachment to the loader.
IMPORTANT: Make sure the quick couplers
are fully engaged. If the quick couplers do not
fully engage, check to see that the couplers are
the same size and brand. Do not force the
quick couplers together.
IMPORTANT: Wipe the ends of the hydraulic
quick couplers (both lead and loader) with a rag
to remove any possible contamination.
Contamination
can cause hydraulic
components to fail and is not covered under
warranty.
NOTE:
See the Loader’s Operation and
Maintenance Manual.
NOTE: Attachment is shipped with 12FJX (1-
1/16” Female JIC Swivel) fittings on the ends of
the lead hoses and a 6FJX (9/16” Female JIC
Swivel) fitting on the end of the case drain hose.
9.
Connect the wire harness to the loader’s wire
harness receptacle. (Disregard if a pistol grip
controller is supplied with the attachment.)
Make sure the hoses are properly routed to fit
your specific loader. If the hoses are not routed
correctly, hoses may get pinched or rub on
tires. Be sure to check the hose routing through
the full range of intended motion of the
attachment before operating it.
More than one routing may be acceptable
depending on the loader. Pick the routing that
best suits your loader.
IMPORTANT: Proper hose routing is the
responsibility of the owner and/or operator.
Pinched or stretched hoses are not covered
under warranty.
NOTE: Make sure the pressurized hose from
the skid steer is routed to the “P” port of the
valve block. If not the attachment will not
operate properly.
Mounting is now complete and you are ready to use
the attachment. Use the above instructions in a
reverse order to dismount the attachment from the
loader.
14 Pin Wire Harness Connection
Hydraulic Connections
Rock Saw Ready for Operation