Erskine Attachments 110X, Safety And Operating Instructions Manual, Page: 14 / 32

110X, 210X, 310X, 360X, 410X
Safety and operating instructions
Preparation
1. Place the breaker in a position where it is easy
and safe to mount the adapter plate.
Mounting the adapter plate
2. Place a locking washer pair on each screw.
3. Tighten the screws with an spanner.
4.
Always use NORDLOCK™ washers under bolt
and nut
(NORDLOCK™ is a registered
trademark of Nord-Lock AB).
7. Carefully lower the stick of the boom into the
adapter.
WARNING Moving parts can crush
and cut
►
Never check bores or passages with hands or
fingers.
An assistant should direct the movement of the
dipper arm until the bores in the dipper arm are
flush with those in the adapter.
Agree with the assistant on clear hand signals
for use during the mounting procedure.
8. Insert the pin and lock
9. Lift up the hydraulic breaker using the boom.
10. Extend the bucket cylinder until the bore in the
toggle is flush with those in the adapter. Insert
toggle pin and lock.
11. After mounting the breaker, carefully extend and
retract the bucket cylinder to its full extent in
each direction. It is important that the cylinder
can be fully extended and retracted without any
difficulty.
Connecting the hydraulic hose
12. Circulate the hydraulic oil before connecting
the hydraulic breaker. This is to make sure that
the hydraulic oil is clean. Use the same
routine when changing the hydraulic oil hose.
For further information see "The hydraulic oil".
13. Connect the pressure and return hose.
5.
200 Nm
390 Nm
14. Run the hydraulic oil through the carrier's oil
filter for approximately 3 minutes to make sure
that the hoses are clean.
410X
390 Nm
Connecting the breaker to the carrier
6. Place the breaker in a safe way at installation.
390 Nm 360X
210X
319X
200 Nm
110X
Tightening torque Adapter plate