10
IP66 RJ-45 Cable
For IP66 RJ-45 cable, please use an RJ-45 IP66 plug for connection to prevent
water damage. Follow the steps below for cable connection.
Step 1:
Take out the supplied connector from the RJ-
45 IP66 plug. Loosen the thread-lock sealing
nut on the plug. Then thread the Ethernet
cable through the thread-lock sealing nut and
the plug. If the Ethernet cable is already
attached to a connector, please remove it first.
Step 2:
Carefully remove a section of rubber coating
from the end of the Ethernet cable to reveal
the wires. Inset the wires to the correct pins of
the connector. Plug the Ethernet cable to the
connector of IP66 RJ-45 cable.
Step 3:
Fasten the RJ-45 IP66 plug to the connector
of the IP66 RJ-45 cable. Lastly, tighten the
thread-lock sealing nut to the plug.
