3.2 SFP Port connection
ELECTRA-T08 SFP port only support Gigabit fiber module. Recommended use of standard SFP
module products
The process of installing a fiber module on a switch is as follows:
First, grasp the optic fiber module from the side, insert it smoothly along the SFP port slot until
the optic fiber module and switch are in close contact;
Second, confirm the Rx and Tx ports of the fiber module when connecting, insert one end of the
fiber into the Rx and Tx ports correspondingly, ensure that the Tx and Rx ends of the interface
are connected correctly and the other end of the fiber is connected to another device;
Third, please check the corresponding indicator light status after power on. If the light blinking
that the link is properly connected, if the light is off , the link is failure, please check the line to
confirm that the corresponding equipment is enabled.
Note
：
Does not allow excessive bending fiber, the radius of curvature should not be
less than 10cm;
Ensure the cleanliness of the fiber surface;
Please do not look directly into the optical fiber connector with your eyes as
this may cause eye injury
3.3 Check before power on
Check whether the outlet power supply meets the switch specifications;
Check the power, switches, racks and other equipment have been properly grounded;
Check whether the switch and other network devices are connected properly
