Use and maintenance manual
Automatic V-guide notcher
Model: VG-22
____________________________________________________________________________________________________________________
P a g . 7
NOTE: If you have not cut off the air supply, this operation will be difficult to perform.
Run the profile up to the last holding brake on the bottom of the head.
Fix the pressure plate for each type of profile.
•
K 6 for (6x4 and 8x5)
•
K 10 for (10x6 and 13x8)
no necessary for 17x11 - 22x14 and 30x16
After running the profile through, put the stamping cylinder back in its position and replace the bolt.
Close the protection door and move the slide valve to restore the air supply.
Once the profile to die cut has been loaded and placed at the beginning, press the green button on the
electric board.
If the Blue reset button is on, press it before START to reset the system.
