Use and maintenance manual
Longitudinal profile welding
Model: LRW-200
_______________________________________________________________________________________________________________________
P a g . 8
Lower the pulleys using the drive system located on the front of the welding carriage so that they
press the belt and are driven by turning the control knob (
P
):
After the welder has been pre-heated, begin welding by turning the control knob (
D
) to start
welder rotation while at the same time pressing the green START button on the control panel to
start the motor.
During the welding process it is always possible to change any of the three settings: temperature,
speed and pressure.
All of these settings have a direct effect on the quality of the weld so a test should be performed
before welding the belt just to make sure all the settings are correct.
The position, angle and proximity of the welder is also very important for the temperature
setting. Increasing the distance or angle in relation to the profile reduces the effectiveness of the
bond between the materials.
