Ermator W350P, Operation Instruction Manual

Page: 4 / 14

Revision 0 3
Function
The motor is started by the switch. Dust laden air is then sucked through the inlet valve at high speed
via the suction hose. The air is slowed down by the cyclone and coarse dust particles are separated
out, partly by centrifugal force and partly by gravity. Air and finer particles then pass through the fine
filter where separation is made.
Use
Before using must the user be educated in handling the vacuum cleaner and the dust.
From time to time the filter must be cleaned or replaced. It´s appropriate when the work is
completed or when there is poor suction.
Connect proper evacuation hose. Fix the free end of the hose.
Left switch:
0: motor off
1: motor on
Right switch:
0: Pump off
1: Pump on
Fit the suction hose on the suction apparatus
There is a hose intake with a hose lock on the tank. Lift the hose lock and insert the suction hose´s
metal adapter into the intake. Lower the hose lock into the recess of the adapter. The hose lock fixes
the adapter in the hose intake and is lifted when the suction hose is to be removed.
Fit the nozzle on the hand pipe
The floor nozzle has adjustable wheels. Adjust the wheel setting so as to achieve the best suction
effect. Adjust the wheels with the knob which is located on the rear side of the nozzle. The wheels and
rubber strips of the nozzle are replaceable. Ensure that the nozzle is kept in good condition.
After use
Switch off the suction apparatus with the switch. Remove the plug on the electrical cable from the
electrical outlet. Do not pull the electrical cable!
Empty and clean the suction apparatus and the accessories used. If necessary, the tank and accessories
can be flushed clean.
Never leave water or wet dirt in the suction apparatus. This can cause bad smells and poor hygiene.
Change of filter
Risk of dust dispersion - Use of personal safety equipment
Unhealthy dust can be spread during filter change. Accordingly, the user should wear protective
glasses, protective gloves, and a breathing mask conforming to protection class FFP3.
1. Remove the plug from the electric outlet.
2. Lift off the filterholder with the filter.
3. Loosen the fingernut and remove the filter cap and filter.
4. Check the sealing on the filterholder.
5. Assemble the new filter.
6.
Clean all other parts.
WARNING
Connect the electric plug to a power outlet with the correct voltage, see the nameplate.
WARNING
Switch off the machine and pull the plug out of the socket.