ERL tesla lite, User Manual, Page: 124 / 288

8 Configuring the Recorder
8-46 TESLA LITE User Manual D03283R01.10
8.18 Printing
Printing a
Configuration
Figure 8.25: Print a Configuration
Generate a Configuration print at any time by selecting Print Settings from the
File menu. The printed output follows the same general layout as the Element
Tree. Where applicable, the settings are given in secondary units. The excep-
tion is the Fault Location parameters which are given in primary units.
You can preview the printed output by selecting Print Preview from the File
menu.
Print Config function is also available under the Config menu.
Printing a
SCADA
Address List
MODBUS
The MODBUS address equivalents shows all of the functions defined in the
TESLA LITE recorder (see “Modbus Functions” in Appendix D). Selecting
the
Print MODBUS settings item from the File menu generates a listing that is
configurable - listing the full function names in Element-Function-Description
format along with the equivalent MODBUS addresses.
You can preview the printed output by selecting Print MODBUS Preview from
the File menu.
Print MODBUS function is also available under the Config menu.
DNP
The DNP point list shows all of the functions defined in the TESLA LITE re-
corder, (see “DNP3 Device Profile” in Appendix E) Selecting the
Print DNP
settings item from the File menu generates a listing that is configurable - listing
the full function names in Element-Function-Description format along with the
equivalent DNP points.