Ericsson LBI-39012C, Operator'S Manual

Page: 27 / 32

OPTIONS
Type 99 Option
If the Type 99 Option is present, individual selective calling is possible.
Press the programmed Flex key or use the menu and CHANNEL/SEL keys to
enable the decoder option (Scan must be off). The LED display will show the
option status: "T99 ON" or "T99 OFF". Press the button a second time to
toggle the option status. The display will revert to normal channel display after
5 seconds. When a call is received, an alert tone will be heard and the display
will flash, alternately "T99" and the channel selected. After receiving the call,
press the CLR button to reset the decoder for the next call. The display will
stop flashing.
If a call was received and the display is flashing, the CLR button must first
be pushed before the T99 option may be disabled.
If the Horn Alert option is present with the Type 99 option, the radio can
beep the vehicle horn when a Type 99 call is received. This option permits
alerting persons out of the vehicle when a call is received. The Horn ON/OFF
switch which is mounted on or near the radio is used to turn off the horn beep
relay.
Public Address Option
If the Public Address Option is present, the radio may be used as a public
address amplifier. Press the programmed Flex key (or use the menu) to enable
the option (Scan must be off). The display will show "PUB ADDR". When the
microphone PTT switch is keyed, the radio no longer transmits, but allows the
microphone audio to feed the speaker. Adjust the VOLUME for desired level.
Press the Flex key or use the CHANNEL/SEL a second time to disable the
option. The display will revert to normal channel display. Changing channels
or turning scan on will also turn the option off.
The public address microphone audio normally feeds an external speaker.
An ON/OFF switch, which is mounted on or near the radio, allows selecting
either the internal or external speaker for the receiver audio. The ON/OFF
switch turns the receiver audio on or off to the external speaker. This switch
still functions for the receiver audio with the PA option disabled.
1. Make sure the radio is turned ON.
2. Press the MNU button until PUB ADDR appears in the display. Press
the PTT switch to transmit the microphone audio to the external
speaker.
3. When the PA operation is completed, press the CLR button to return
to normal operation.
27