UNPACKING AND CHECKING EQUIPMENT
When ready for installation, carefully unpack the radio and any accesso-
ries. It is recommended that you identify each item in the packing case. If
any damage has occurred to the equipment during shipment, file a claim
with the carrier immediately. The following is a list of equipment packed
with the radio.
*
FMD Radio Unit
*
Package of mounting hardware
*
Mounting bracket
*
Power Cable
*
Microphone
*
Microphone hanger
*
Remote internal speaker (optional with FMD scan model)
*
External speaker (optional)
*
Emergency switch (optional)
*
Operator’s manual
*
Installation manual
PLANNING THE INSTALLATION
Before starting, plan your installation carefully so that it will be:
•
Safe for the operator and passengers
•
Convenient for the operator to use
•
Neat
•
Protected from water damage
•
Easy to service
•
Out of the way of auto mechanics
•
Out of the way of passengers
4
ANTENNA
Installation instructions for the antenna are packaged with the antenna.
The antenna must be installed in accordance with good engineering practices
for optimum results.
The most effective mounting position is usually in the center of the roof
of the vehicle. The antenna cable will normally run from the radio, behind
sections of the interior trim to a door or window post. Then run the cable up
between the roof and headliner in the passenger compartment to the antenna
base.
Once the antenna is installed, connected it to the TNC connector at the
left rear of the radio.
HORN SPEAKER (OPTION)
The horn speaker may be used as an external speaker. It may be mounted un-
der the hood, on the vehicle roof, or other suitable location. The horn
speaker option includes horn speaker and speaker cable assembly.
Figure 8 - Microphone And Microphone Hanger
Be careful to avoid damaging some vital part (fuel tank, transmission
housing, etc.) of the vehicle when drilling mounting holes. Always
check to see how far the mounting screws will extend below the
mounting surface before installing.
CAUTION
13
