Advanced Configuration
60
EN/LZT 108 6377 R4 - September 2003
1. Click the
Create a new route
button. The following page appears:
2. Enter parameters according to information in the table below and
click the
Apply
button.
3. Select
System > Save Configuration
and click the
Save
button to
save your new settings.
Description of parameters when creating a new Static Route:
Parameter
Description
Destination Address and
Netmask
Identifies the destination IP address and netmask of
the network where data packets are to be sent.
For default route enter 0.0.0.0 or leave the fields
blank.
Forward packets to
Select
Gateway Address
and enter the IP address
of the gateway on the LAN where data packets are
to be sent. This is to be configured only when the
LAN interface is configured as a route.
or
Select
Interface
and from the drop-down list select
the ATM PVC interface where data packets are to
be sent.
9.6.5.2 Dynamic
Routing
On the
Configuration > IP Route > Dynamic Routing
page you can
enable/disable the Routing Information Protocol (RIP) that will help routers
to determine optimal routes.
