5
LED indications of HBS2
On the front of the HBS2 four Light Emitting Diodes (LEDs) are situated. The LEDs
give indications as described in the Table 1 below.
The LEDs labeled Member and Guest are only used in relation to the pairing
sequence and will be turned off after a short time. Pairing mode lasts 2 minutes
from the pairing button is pressed.
Table 1
Various LED indications on the HBS2
LED state
User action
State
Status
Member Guest
Restart
-
HBS2 is connecting
▌▌▌▌▌
Idle -
Idle
█████
Traffic -
Traffic
ongoing
█
█
█
Member pairing Single push
Prepare HBS2 for member pairing
▌▌▌▌▌
Guest pairing
Double push
Prepare HBS2 for guest pairing
▌▌▌▌▌
Pairing success -
█████
█████
Pairing failure
-
█████
█████
Fatal failure
§)
-
Failure in HBS2
█████
Reset to Factory
default settings
Push Reset button for
more than 3 seconds
Resets all parameters to factory default
settings
▌▌▌▌▌
▌▌▌▌▌
▌▌▌▌▌
███
= Steady;
▌▌
= Flashing Fast;
█
█
= Flashing Slowly
§)
An indication is seen briefly and a reboot will begin shortly after
█
= red
█
= green
The LED marked “
LAN
” indicates the activity on the LAN connection by blinking or by steady green light.
A quick single push on the “Push button” (see
Figure 6
) on the rear panel aborts an ongoing pairing sequence.
Figure 5
Front panel of the HBS2