Ericsson ECN320, User Manual

Page: 139 / 188

Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
131
ntp Set the NTP server and client 138
password Change password and set minimum
length of password 140
pem-management Enable or disable PEM management 140
radius-server Configure or disable the configuration of
RADIUS client 142
restore-configuration
Restore configuration information in the
EMP and the embedded elements 143
service-vlan Configure or remove Service VLANs 143
show Show configuration 145
turn Turn off the SBC board
update Install ENC SW 147
vlan-unaware Enable or disable VLAN unaware mode
of the switching unit 147
11.6.10.1 aaa
The command is used to enable or disable the configuration of the RADIUS
authentication when logging in to CLI. For further information of how to con-
figure the AAA client refer to section 11.6.10.12 on page 142.
Command level:
ecn330(config system)#.
Syntax
aaa authentication login {enable|disable} radius
Arguments:
•
enable/disable –
enable or disable the use of an AAA server
(RADIUS server).
Default Setting
disable.