ERICSON EDACS LBI-39153, Maintenance Manual

Page: 15 / 86

COMPACT VERTICAL VOTER CONFIGURATION LBI-39153
15
NOTE
Power must be applied to the Digital Voter when
programming the Digital Receiver or Selector.
2. From the "VOTER" directory, run the leafoff.exe
program by entering the command:
" leafoff hexfile .hex-1 ".
Replace "hexfile" with the Voter software file
name.
3. The program will reset the Digital Receiver or
Selector and run the Flash Loader program. The
program erases the existing Voter software residing
in the Flash PROM U25 and writes the new Voter
software into the Flash PROM.
When the program is finished, the PC will display
the message "Radio Programmed. Closing down
port COM1." Wait a couple of seconds before
disconnecting the programming cable from the
"
PROG
" connector. This allows time for the PC
to reset the Digital Receiver or Selector and
initialize the Voter application program loaded in
the Flash PROM.
4. Repeat Steps 2 and 3 to program additional Digital
Receivers or Selectors.
NOTE
To save time, it is possible to set up a batch file to
run the Flash loading program. The following is an
example batch file.
Name the batch, for example, FL.BAT. Names in
italics, such as "voter" is the name of the directory
where the hexfile and leafoff reside. The file
named "hexfile" is the file to be loaded and
"leafoff" is the executable program. Enter the
following batch program:
cd\ voter
leafoff
hexfile
.hex-1
The batch file performs the operations outlined in
Step 2. To run the program, type "FL" <enter> to
program the Digital Receiver or Selector.
If any difficulty is encountered when loading the
program, refer to the Troubleshooting section in this manual.
Check out the Digital Receiver and Selector operation.
If any problems are encountered, refer to the troubleshooting
procedures in this manual and LBI-39151.
POST CONFIGURATION CHECKS
1. Check Main Site GETC and Satellite Site Receivers for
proper configuration.
2. Check Backplane for proper installation of jumpers on
J6, J7 and J8.
3. Check EDACS Interface Panels for proper installation
of the jumpers on J30, J31, J40 and J41.
4. Check all Digital Receivers and Selectors for the correct
Configuration Plug and DIP switch settings.
5. Check all RMICs for proper installation of jumpers on
X3 and X4 and line level switch settings.
6. If Simulcast Digital Dispatch, ensure modified RMIC(s)
is installed in slot 2 and slot 12 (if 2-channel).
7. Ensure all modules are installed in their proper slots
according to the Card Configuration Table.
NOTE
NOTE