User Manual
6
Adhesive achor (Art.Nr.: 56852)
1. Drill and clean a hole for the bold.
Note: Installation is only permissable in concrete quality B25.
2. Inser the cartridge into the borehole.
3. Fit the UPAT – setting or socket wranch SW12 into the drill
hammer or percussion drill. Attach the anchor rod an charge by
vibration up to the mark, then immediately switch off the machine
and remove the setting tool from the machine.
4. Postitioning of the groundsocket.
5. Tighten the adhesive anchor with hex-nut and disc to 80 Nm.
6.2. Game post
1. Insert game post (1/2) into the opening of
the groundsocket (3).
Note:
The two rolls on the end of the game post have to be on
top (upper side).
Consider the position of the posts to the groundsocket.
Game post is held by rubber cables,
suspended through a 10 cm long range.
2. Infinite height adjustment of game post (1/2)
Loosening of the fixing screw.
Positioning of the game post in desired height.
Thightening of the fixing screw.
flush floor
(1/2)
(1/2)
(3)
(1/2)
(3)
fixing screw