Ergotron WORKFIT Manual Download Page 10

10 of 12

555-24-002-G-00 rev. B • 04/19 

DANGER! Electrical cables can be hazardous.

Misuse can result in fi re or death by electrical shock. 

These symbols alert users of a safety condition that demands attention. All users should be able to recognize and understand the signifi cance of the following Safety 

Hazards if encountered on the product or within the documentation.  Children who are not able to recognize and respond appropriately to Safety Alerts should not use 

this product without adult supervision!

Hazard Symbols Review

Symbol

Signal Word

Level of Hazard

INSTRUCTIONS

Refer to instruction manual/booklet.
Follow instructions for use.

CAUTION

A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the 

problem.

WARNING

A WARNING indicates either potential for property damage, personal injury, or death.

DANGER

A DANGER indicates a hazardous situation that, if not avoided, will result in death or serious injury.

Safety

There are specifi c risks associated with the use of equipment having power cables. You must 

be aware of, and avoid these risks when located in close proximity to children.

   WARNING: Failure to observe the following Electrical Safety notices can result in fi re or 

death by electric shock.
Electrical cables can be hazardous. Misuse can result in fi re or death by electrical shock. 

• Inspect power cables thoroughly before each use.

• Do not use cables that are damaged.

• Insert the plug completely into the outlet. 

• Grasp the plug to remove from the outlet. 

• Do not unplug by pulling on the cable. 

• Do not use excessive force to make connections.

• Do not plug the cable into an extension cable.

• Do not remove, bend or modify any metal prongs or pins of cable.

• Do not drive, drag or place objects over the cable.

• Do not walk on the cable.

• Avoid overheating. Uncoil the cable and do not cover it with any material.

• Do not run cable through doorways, holes in ceilings, walls or fl oors.

Keep away from water. 

• Do not use it when wet.

• Do not place in close proximity to fl ammable liquids or gases. 

The power disconnect for this equipment is the AC power cable. 

Therefore the socket outlet should be easily accesible and should be installed near the 

equipment.
Electrical devices are not toys. Children are often unaware of the hazards associated with 

electrical devices, so this unit must always be used by adults or with adult supervision.

User Must be aware of the surrounding environment while operating the this product.
Do not use this unit outdoors.
Liquids should not be stored in, set on or placed inside this unit.
Never unplug this product from the outlet when your hands are wet.
Ergotron does not accept any liability for damage if the unit is misused, incorrectly operated or 

inadequately repaired. Under these circumstances the warranty will be void.
Any modifi cations made to this device that are not approved, may void the authority granted to 

the user by the FCC to operate this equipment.
This product is for use on a nominal 120-volt circuit and has a grounding plug that looks like 

the one shown below. make sure that the product is connected to an outlet having the same 

confi guration as the plug. No adapter should be used with this product.

Electrical Rating:

120VAC~ 60Hz, 400W

Environmental

Temperature range:

Operating 0° to 30°C (32° to 86°F)

Storage -40° to 60°C (-40° to 140°F)

Relative humidity (maximum):

Operating 10%–90% (non condensing)

Storage 5%–95% (non condensing)

Altitude (maximum): 2000 m (6,562 ft)

Certifi cation:

UL 962 Standard for Household and 

Commercial Furnishings, 

CAN/CSA C22 2 No. 203.2-14

ICES-003 Issue 5, Class A

FCC Part 15 Class A

RoHS and REACH compliant material used.

This device complies with Part 15 of the FCC Rules. Operation is 

subject to the following two conditions:  

1) This device may not cause harmful interference. 

2) This device must accept any interference received, including 

interference that may cause undesired operation. 

CAN ICES3(A)/NMB-3(A).

Changes or modifi cations not expressly approved by the 

Ergotron could void the user's authority to operate the 

equipment.

Intended for institutional use.

Summary of Contents for WORKFIT













Reviews: